Drying of FilDry filament

FILDRY Dryer designed for drying thread-like plastic in coils (filament). The coil compartment is designed for drying 2 coils with a diameter of 200-205 mm and a width of up to 65 mm or one with a diameter of 200-205 mm and a width of up to 130 mm.

The use of this dryer will avoid defects that occur due to high humidity of the filament, such as:
- reduction of the strength characteristics of the printed product;
- poor surface quality of the printed product;
- increased fragility of the printed product;
- omissions in the filament feed;
- "traffic jams" and failure of the extruder (print head).

The main advantages of this dryer:
- the dryer is designed for 2 coils, so it is convenient to use it for printers that have the ability to print with 2 materials;
- the method of fixing the coils reduces the likelihood of unwinding and entanglement of the filament;
- there are 2 holes for the output of the filament thread, so that it is possible to print from the dryer, which is especially important for nylon
- compact, so it does not cause discomfort during storage and transportation
- a powerful 250 W heater allows you to stably maintain the set temperatures and dries the air well.