3D Printer 3DQ ONE V2

3DQ One V2
The new version of the 3DQ One 3D printer has the following advantages compared to its predecessor:

• Enlarged print area (290 mmx220mmx210mm)
• The possibility of using the device as a laser engraver with an engraving area (260 mmx200 mm)
• Closed housing made of composite material
• The function of reducing the moire on the surface during 3D printing
• Automatic calibration of the desktop with the use of contactless sensors
• A 32-bit control board that provides more accurate and reliable 3D printing
• A rod motion sensor that pauses the 3D printer not only when the plastic is finished, but also if for some reason the plastic supply is difficult (for example, when the loop is on the coil)
• Ventilation systems and filtration of the inner chamber to reduce the smell during the laser engraving process
• The mode of safe use of the laser engraver function, which turns off the laser engraver when opening the lid of the device, which has a special coating to protect the eyes from the action of the laser
• At the same time, the device retains the main advantages of the 3DQ One 3D printer, namely:
• The presence of a screw drive on all three axes, in which the positioning accuracy does not depend on the belt tension, but is determined by the accuracy of the lead screw. There is no need to tighten the belts.
• The lead screws allow you to move the executive element of a large mass without losing accuracy, which made it possible to use a direct drive, in which the feeding mechanism and the nozzle are at a minimum distance. This allows the 3D printer to print very well with soft types of plastic (Flex, Rubber)